While viewing the alarm time, a long press of SW1 will enter the set alarm mode, at which point only the digits being set will blink. This is done to differentiate between viewing the current time and the currently set alarm time.

When viewing the currently set alarm time, the display will blink. Another SW1 press will exit set time mode and the clock will return to display the current time.Short SW1 presses cycle through setting and enabling the alarm. A short SW1 press will then move to the minutes where operation is similar to setting the hour. Holding SW2 down will cause the clock to increment quickly after 1 second. Short SW2 presses will increment the hour by 1. Timer currently resets after 60 minutes.A long SW1 press while viewing the current time in HH:MM format will enter the set time mode. The timer will continue to increment (if running) even when cycling through other modes. A short SW1 press will toggle the start/stop of the timer. A short SW2 press will then enter the timer mode.

A short SW1 press while on the 12/24-hour display format will toggle the setting. More information (part lists, (YouTube) tutorials, configuration examples, etc.) can be found on !Ĭircuit OperationShort SW2 presses cycle through displaying the current time in HH:MM and MM:SS format as well as the 12/24-hour display format option. Fully 12v and 24v compatible with a max input voltage of 36v for running other loads (flyback diodes and capacitor optional for inductive loads!).Using a pluggable ESP32 and the QuinLED-ESP32 the board can be configured with an ESP32 with onboard antenna, external antenna or even wired Ethernet!! Please note that to be able to build this board you will require to order a stencil with it !Total cost per board with components is less than xx.xx$.

The board has specifically been designed for high power setups where you might want to run several high powered white LED strips too, allowing a max of 10Amps over a single MOSFET or ~20Amps for the total board. The QuinLED-An-Penta is a 5 channel ESP32 based analog PWM LED controller/dimmer! Designed to run WLED or ESPhome it is the ideal board for running LEDs standalone using an App or tied into Home Assistant natively! Designed to build yourself, easy to solder!Unique properties are high current handling, 2x onboard fuse, 4x Positive and 5x Negative (LED channels) terminals to run any combination of LED setup from RGB, RGBW to RGB+CCT (RGB + Dual White) all possible.

Estlcam jpg